Archive

UDK: 624.075.4:69-009.182
DOI: n/a

Published: Građevinar 52 (2000) 12
Paper type: Original scientific paper
Download article (Croatian): PDF
Download article (English): n/a

Design of thin-walled trapezoidal profiles exposed to bending action

Diana Šimić, Boris Androić

Abstract

Procedures for designing trapezoidally shaped cross-sections of thin steel sheets according to DIN 18807 and Eurocode 3, are analyzed. The effective cross section is considered instead of the gross cross section. Calculated values of cross-sectional resistance are compared with cross-sectional resistance values obtained by laboratory testing of trapezoidal sheets produced by a domestic manufacturer. Safety checks involving partial safety factors (EC3) and global safety factor (DIN 18807) are commented on.

Keywords
participating width, effective cross section, DIN 18807, Eurocode 3, limit state, thin steel sheet, safety factors

HOW TO CITE THIS ARTICLE:

Šimić, D., Androić, B.: Design of thin-walled trapezoidal profiles exposed to bending action, GRAĐEVINAR, 52 (2000) 12

OR:

Šimić, D., Androić, B. (2000). Design of thin-walled trapezoidal profiles exposed to bending action, GRAĐEVINAR, 52 (12)
Authors:

Diana Šimić
University of Zagreb,
Faculty of Civil Engineering
Androic WEB
Boris Androić
I.A. projektiranje d.o.o., Zagreb
Croatian Academy of Engineering